HDMI CEG Setup

  • Thread starter Thread starter x-xxxA
  • Start date Start date
X

x-xxxA

I'm trying to to have the TV on standby when the decoder is on standy and stwitch on TV when I switch on the TV. I have been trying to setup the HDMI CEG, but haven't succeeded. Now I have messed up the setup that have lost hope. I have OPB release 1.0.0.23. Any help will be appreciated.
 
If you had googled a little bit for this problem, you'd found out that HDMI CEC is a protocol not perfectly adopted by every TVs.
Switching on TV when you switch on the STB is quite possible and common, as far as I know; putting in stand-by the TV when you put the STB in stand-by or deep s.b. is a completely different matter, unfortunately, and it depends on TV, not on STB or images.
 
I had it with OBH v1.0 but with earlier release than 1.0.0.23. Today I flashed it again and did upgrade to 1.0.0.23 and could it do it. Could be that the HDMI CEG is different than it was before.
 
Sorted out. I needed more patience and more attention to save when you edit setup.
 
You must log in or register to reply here.
Back
Top