SCR "Connected to" option disappeared in 4.4.010

  • Thread starter Thread starter Alexwilmac
  • Start date Start date
A

Alexwilmac

I hadn't noticed until today but the option "Connected to" is now visible only where it must be set to no (in the case of Solo4K, tuners A and B).
It is not visible entering the setup ov FBC virtual tuners.
So I launched OpenVix, copied the config.nims lines from its "settings" file and used its lines under OBH.
Tuners works as intended but the "Connected to" option is not visible.
I suspect this happened after the update from 4.4.009 to .010 so I loaded a previous backup, and I was right: in the 009 release the options were at their place.
 

Attachments

  • Connected-disappeared.jpg
    Connected-disappeared.jpg
    355.4 KB · Views: 12
Last edited:
It also disappeared the Signal Finder screen. At least, this is in the Solo4K release, the only VU+ I've got where I can check these options. The other two don't have FBC tuners.
 
You must log in or register to reply here.
Back
Top