Recent content by djuro1

On that satellite and that frequency, on every picture, it shows such a signal, tested on vu duo 4k se, picture, open atv 7.3, obh 5.2 and 5.3, openpli 8.3., so it's not a problem.

I did a fresh install of the image, and it seems to me that the multiboot image selector Enigma does not crash, up to 11 slots, when I add slots from 12 to 15, Enigma crashes. When I delete slots from 12 to 15 everything is ok

Enigma crash and when I try to install an image, Backcup Images Manager, Image Manager, I highlight the image and press ok and Enigma crash

Menu, Standby Restart, MultiBoot Image Selector. I installed a clean installation in Slot 1 and Enigma crashes the same, multiboot works normally from all other images

When running multiboot, enigma crash. Duo 4k se

Of course it depends, but this difference in temperature is in the state of unloaded processor operation. On opepli and openatv the temperature is the same as on obh 5.2.007

I noticed an increased processor temperature on OBH 5.3.002 compared to OBH 5.2.007, receiver vu duo 4k se. Has anyone else noticed an increase in temperature on the vu duo 4k se?

Great work, kernel patch tested and works on openpli 8.3, openpli develop, Nonsolosat-27 and BH image. Thank you

Are there any solutions for vu solo 4k, for openpli image and bh image, I only managed to start after installing openpli 4.0

There is a solution, remove all usb, go to slot 0-RecoveryStart, after that do the initialization ssd disk and the possibility to add slots from 4 to 7 will appear, after that there will be no more possibility to add slots, but you can add it manually in the receiver slot 8 and so on further...

It's not done automatically, those teams have to go in their image for it to show automatically, but that's why Matrix10 made a simple image selector by slots for images that don't show Multiboot image selector

In order for image names to appear, you must change the name in menu.xml instead of Start image slot 1, write Start image and then the image name. </code> </item> <item weight="0" level="0" text="Start image OpenBh 5.2" entryID="start1"> <code> from...

This only happens with obh 4.4 and even on it if I change the name of the image to another name I can install it normally, very strange behavior

Correct, but when I choose, the installation slots do not appear, but when I specify the slot in which I will install and press ok on the remote, Enigma falls and the receiver restarts

I enter the backup images manager and select the image for installation and press ok on the remote, after that it throws out a message