OpenBH 1.0 Vu+ Solo4K

  • Thread starter Thread starter Ev0
  • Start date Start date
If, for settings, you mean just channels, yes, they are, as always. You can save them through some settings editor and then restore them after flashing.
As for the plugins and every other aspect related to OBH personal backup, in my case OBH 1.0 was not able to use it and I had to reinstall plugins and configure NAS, etc.
 
After power failure the standby not exists in version OpenBH 1.0 ???????????????
 
Did anyone install the transmission plugin? I have installed but it doesn't work. When i try to run transmission-daemon it says \etc\init.d\transmissiond: not found. Any help appreciated.
 
Force de-interlace option in av settings doesn't work. I set "yes" for this setting but instead receiver outputs interlaced video when the source is interlaced.
 
Also regarding av settings - doesn't work "multi" option in refresh mode when the autoresolution is disabled. When i choose refresh rate multi it should display 24 Hz content with the same frame rate but it outputs 60 Hz instead.
 
zigomar said:
I do not understand ... more explanation STP
Click to expand...

Is it difficult?

1) - Use the <up> or <down> arrow buttons. (SC_1)

SC_1.jpg


2) - Select the service you want to apply the service that must be displayed after booting. (SC_2)

  • Press the <MENU> button.
  • Choose " Set as startup service ".
SC_2.jpg


3) - Press the <OK> button and choose from the 2 options the one you want. (SC_3)

  • Note: generally i make the choice ( 2nd one ), "also on standby".

SC_3.jpg



best regards
nunigaia
 
thank you
This I know but it does not solve the problem ... when a power failure the VU + restarts and the TV starts which is annoying at night or in case of absence. This is not the "startup to standby" function ...
cordially
 
zigomar said:
thank you
This I know but it does not solve the problem ... when a power failure the VU + restarts and the TV starts which is annoying at night or in case of absence. This is not the "startup to standby" function ...
cordially
Click to expand...

Test this! And reply.

Note: When the STB boots up or you restart enigma ... it goes allways to standby mode. You have to press the power button to revert "standby mode" to operating mode.
best regards
nunigaia
 

Attachments

Thank You nunigaia :)

This is exactly what I was looking for (traduction Google because I'am french)

Merci.
 
You must log in or register to reply here.
Back
Top