Clean Install failure on Zgemma H11S

[azamsaghir]

My Zgemma H11S box does not boot up after I am doing a clean install of latest OpenBh 6.0.005.
Using the external USB method the flash process completes successfully but after rebooting the box remains stuck on the following screen...



I can connect to the box using Telnet and FTP.

I have repeated the flash process three times and each time it remains stuck on the splash screen after rebooting.

Please can you advise.

Thanks
Azam

 

[Ev0]

You say you have telnet access.

So can you telnet into the box, and use command:

init 2
killall -9 enigma2

enigma2

Then it should tell you what is stopping it from booting, just paste that error here.

 

[azamsaghir]

I used your commands in Telnet and the box remains stuck on the splash screen however I have attached the file which hopefully you can work out the error.

 

[Ev0]

Ok it seems like there might be an EGL issue.

This could take a bit of time to get to the bottom of.

 

[azamsaghir]

OK thank you. Please take your time.
Just to let you know that I had no issues whatsover installing OpenBh 6.0.005 on my other two boxes - Octagon SF8008 Supreme and Vu+ Uno4K.

 

[Ev0]

Ok I think I found the issue, image is rebuilding but will take many hours due to oe-a git updates.