Clean Install failure on Zgemma H11S

A

azamsaghir

Member
My Zgemma H11S box does not boot up after I am doing a clean install of latest OpenBh 6.0.005.
Using the external USB method the flash process completes successfully but after rebooting the box remains stuck on the following screen...

OpenBh_Fail.jpg

I can connect to the box using Telnet and FTP.

I have repeated the flash process three times and each time it remains stuck on the splash screen after rebooting.

Please can you advise.

Thanks
Azam
 
You say you have telnet access.

So can you telnet into the box, and use command:

Code: 
init 2
killall -9 enigma2

enigma2

Then it should tell you what is stopping it from booting, just paste that error here.
 
Ok it seems like there might be an EGL issue.

This could take a bit of time to get to the bottom of.
 
OK thank you. Please take your time.
Just to let you know that I had no issues whatsover installing OpenBh 6.0.005 on my other two boxes - Octagon SF8008 Supreme and Vu+ Uno4K.
 
  • Like
Reactions: Ev0
I attempted the clean install again today and I am happy to report that all went well.
The box now completely and successfully boots up with OpenBh 6.0.005.

Out of interest what exactly was the fix that was made?

Anyways, thanks again.

Azam
 
Glad the update finally built and uploaded, took almost 20 hours in total lol.

The issue was my fault, I missed adding H11 in 1 place so some needed files were not built for that box.
 
You must log in or register to reply here.
Back
Top